Affiche pl?iade

[Isabelle35]

Hello Fellow PGers!
I have a few projects in mind. I'm planing to make shamballa style bracelets and necklaces with tahiti pearls and sterling silver beads using korean wax cord in one part, and kangaroo lace. My pearls are undrilled at the moment. I would like to know the size of the drill hole needed if I use 1.5mm or 2mm gauge cord/lace. Do you use specific tools to "thread" more easely through the pearl/bead hole? Thanks in advance for you precious help

 

[pattye]

I just trim the cord at an angle with leather to thread through the hole. Haven't worked with waxed cord. Usually one would need holes just slightly larger than the lace. But depends if you are knotting right next to the hole, in which case 1.5 cord works with 2.0 hole. If you want a fluid look with pearl fit tightly to the cord, that is trial and error! (Cord can vary slightly from mm size given.) Please report back what works for you and good luck with your pieces, oh, photos too, please!

 

[Isabelle35]

thanks Pattye for the advice. Not to worry, pictures to come once the project is done!

 

[pattye]

Just wanted to add that some lacing is round, in which case the fit will be tighter than if the lacing is flat and can be squeezed a bit in the hole. Also use a gauge to check the actual size of the lacing, as it may vary slightly.